Operation Manual

21
- Press "UPGRADE" button in the DfuSe program (3 step on pic)
- After a couple of seconds the DFU will uploaded to the beacon. Make sure it actually
takes 1-3 seconds, but not immediate. Otherwise, it is not really uploading the SW. If
immediate, check with "Choose" button you use or even change the version of DfuSe
SW to another one
- Move the DIP switch in normal mode - Power = ON, DFU = OFF
- Start the Dashboard and press HW reset button
- Check SW on the beacon afterwards
- Everything should be OK with the SW now. DFU programming is completely finished
4.4.5 Upload the regular beacon’s HEX SW from http://www.marvelmind.com/#Download to make
sure that the latest set of SW is used
4.4.6 After the DFU SW upgrade the futures SW upgrades can be done in a regular manner via the
Dashboard
4.4.7 Here is the
link for modem DFU programming. All steps are very similar for modem and for
beacon