Manual

66
control the table of distances. Choose Enter
distance for pair to enter the value
Step 3. Now, enter measured (measure it with laser distance
meter or so) value. That values would not change
until you unfreeze or clear it. Even if beacons had
been moved, distance would stay. Be careful with
frozen cells because a small mistake can cause a
significant impact on your tracking
Step 4. Repeat for all cells
4.3.24 Make a service zone, clicking on the map with Shift+Left Mouse
Button. See Submaps chapter for more details
4.3.25 Freeze the map by clicking the button. Stationary beacons will stop
measuring relative distances and will be ready to measure distance
from the mobile beacon(s)
4.3.26 Turn on and wake up the mobile beacon following the same steps
as with the stationary beacon: https://youtu.be/A4aRsjH2-_E
4.3.27 If you see on the devices’ panel in the Dashboard that the beacon is
colored orange, it means there are some differences in some of the
settings between beacons. For example, some sensors may be off