Operation Manual

31
6.7 Modem’s settings
This bar allows user to adjust devices very precisely. It contains a lot of parameters for advanced usage
Modem’s settings
Location update rate settings: 1/20Hz – 16Hz+.
Notice that real update rate may be limited by distances
between beacons or radio profile
TBD
Internal filter. More – faster objects can be tracked. Less –
better filtering against location jumps
Set of power saving features. May not work in all settings or
all SW releases. Keep disabled, if unsure
Averaging between location update measurements. More
value – less location jitter, but higher latency
Filter of distances (as opposed to filter of locations). More –
better filtering, but may be too conservative and “kill” good
measurements
Keep Enabled normally. Switch to cm for backward
compatibility
If map is frozen, new beacons will be accepted in the map,
if enabled
TBD
Unique processor ID for each device (beacon or modem)