Operation Manual

21
- The system may run the frequency search, if it is the very first time you are waking
up the beacons. If this step does not work, disconnect the modem and connect that
beacon again via USB. Press the DEFAULT button in the Dashboard and the Read
All button to make sure that the radio settings are really the default ones
- Compare the radio settings on the modem and the radio settings on the beacon.
They must be the same
- Now you can check the height position of the beacons, RSSI, radio channel,
threshold, etc. on the panel on the right corner of the Dashboard
- It is possible to manage 30 beacons simultaneously. In current version one modem
supports 30 beacons. If you do not see some of your connected beacons on the
map, you may need to scroll to find their addresses
- Double click on the device both to put it into sleep mode and to wake it up
- The map will form and zoom in automatically
- If the map does not form well, check the table of distances in the left corner of the
Dashboard. The cells must be colored in white; it means the distances between
stationary beacons are measured correctly
- If you see in the table some empty cells or marked yellow/red, it is an indication
that distances between Some beacons are measured inconsistently or not