Manual

5.1.15 Notice, that if the modem is not active and is not powered, the beacons

will go into sleep mode automatically after 1 minute

5.1.16 The system may run the frequency search, if it is the very first time you

are waking up the beacons. If this step does not work, disconnect the

modem and connect that beacon again via USB. Press the DEFAULT

button in the Dashboard and the Read All button to make sure that the

radio settings are the default ones

5.1.17 Check that the radio settings on the modem and the radio settings on the

beacon are the same

5.1.18 Now you can check RSSI, voltage, ultrasonic filter settings, etc. on the

panel on the right corner of the Dashboard

Only 4 stationary beacons may be in 1 submap. If you wake up more

beacons, create new submap for them. Or it won’t be displayed on

the map and in the table of distances.

5.1.19 Enter the height of stationary beacons. Choose beacon in the list and

enter height value

5.1.20 Enter the height for mobile beacon if you use 2D mode

5.1.21 In the current version one modem supports 250 beacons (mobile +

stationary combined). If you do not see some of your connected beacons

on the map, you may need to scroll to find their addresses

5.1.22 Double click on the device both to put it into sleep mode and to wake it

5.1.23 The map will form and zoom in automatically