Manual

85
at top window in the Dashboard and run the installation file, then
click on the link under and install the driver
Ensure that:
(e) You are programming the modem’s SW to the modem
and the beacon’s SW to the beacon
(f) You are using SW for 4.9, if you have HW v4.9; and you
have the SW from the same SW pack, i.e., the
Dashboard SW, modem SW, and beacon SW must be
from the same SW pack. Don’t mix SW releases
If SW flashed SUCESSUFLY, MOVE DIRECTLY TO 4.6.6. If you have
some problems with HEX programming, use DFU programming:
DFU programming or SW uploading is used when HEX SW uploading in
the Dashboard cannot be used. For example, when you are updating
from a very old SW version or when the SW includes major changes to
the system and the only possible way to update the SW is via DFU
programming
- After the DFU SW upgrade, futures SW upgrades can be done
in a regular manner via the Dashboard
- Industrial beacons have magnetic DFU mode and reset
- Download the latest SW package, unzip it, and select the proper
version of the SW for your HW and for your frequency variant.
Remember that for DFU programming, you should use DFU SW
(DfuSe), not Dashboard’s .hex file
- Download DfuSe
- Here you will find different versions of DfuSe. v3.0.4 or v3.0.5,
whichever works the best for your Windows: DfuSe v3.0.4 or
DfuSe v.3.0.5
DFU Programming:
Uploading Beacon Industrial’s (Not super) DFU software to Industrial
Super-Beacon hardware make permanently damage for Industrial Super-
Beacon board. Be double attentive with update
- Activate DFU mode and reset the beacon (Industrial
beacons have magnetic DFU mode and reset). Place first
magnet (any strong and modern magnet) to the right side
of the beacon (Step 1). After that, place second magnet
to the left side of the beacon and remove it in a second,
just to reset it (Step 2)
Step 1: DFU mode