Manual

76
4.5 Starter Set NIA-02-2D
The steps below describe the very first time you set up the system. Mini-RX, Mini-
TX beacons and modem required.
Mini-RX and Mini-TX have different HW and SW from HW v4.9. Use Mini-RX SW
for Mini-RX beacons, Mini-TX SW for Mini-TX beacons, HW v4.9’s SW for HW
v4.9
4.5.1 Unpack the system. Take a look at a similar unpacking video of HW v4.9.
The videos have certain differences but the basic are the same:
https://youtu.be/sOce7B2_6Sk
4.5.2 Charge all the beacons using USB cable. Full charging takes about 1-2
hours
4.5.3 Turn the beacons on (To turn Mini-RXs on, carefully disassemble its
housing and find DIP switches inside. It is necessary only for the first
start. You can also turn it off with switches for long-term storage): Place
DIP switches as shown on the picture below
4.5.4 Download SW Pack
4.5.5 Update all the beacons:
‒ Run the Dashboard and update the SW for all beacons and
modem using Dashboard => Firmware => Choose the file =>