Manual

112
5.3.7 Write down the beacon’s address for future use or change the address
at your convenience as shown here
5.3.8 Press the RESET button on your beacons and modem after
programming.
5.3.9 After programming devices with the latest software, the modem and
beacons are ready for use.
5.3.10 Place the stationary beacons high on the walls vertically in a way that will
provide optimal ultrasonic coverage. Write down the beacon’s height for
future change in the settings. The help video on installation can be found
here - https://youtu.be/WY0HkLzmjys
5.3.11 Connect the modem/router via USB to a Windows PC with the
Dashboard installed.
5.3.12 Run the Dashboard. In the left corner of the Dashboard, the modem
should be shown as connected.
5.3.13 Wake up all beacons by clicking on the buttons in the Dashboard on the
panel.
5.3.14 It may take up to 7-10 seconds for the beacons to wake up