Manual

108
5.3 Starter Set IA-02-3D
The steps below describe the very first time you set up of the system. Mini-RX-
beacon, HW v4.9 beacons and modem required.
This is Inverse Architecture. Beacons HW v4.9 should have different
frequencies. Use IA Software ONLY.
You can’t just switch HW v4.9 beacon to another frequency, it is HW depended
Ultrasonic can't be changed to default. You must check the frequency on the
white sticker
5.3.1 Unpack the system. Take a look at the similar unpacking video of HW
v4.9. They are different, but have some similar basics:
https://youtu.be/sOce7B2_6Sk
5.3.2 Charge all the beacons using USB cable. Full charging takes about 1-2
hours
5.3.3 Turn the beacons on (To turn Mini-RXs on, carefully disassemble its
housing and find DIP switches inside. It is necessary only for the first
start. You can also turn it off with switches for long-term storage): Place
DIP switches as shown on the picture below
5.3.4 Download SW Pack
5.3.5 Update all the beacons
‒ You need Inverse Architecture SW (go to
marvelmind_SW_xxx_xx_xx\Software_ia)