Operation Manual

22
measured at all. Try to re-position them because usually there is an obstruction of
some sort in the between the beacons. It also may be different height of beacons’
positon. Reset all these beacons.
- Use View => Table of distances to monitor the measured distances between
beacons
- Freeze the map by clicking the button. Stationary beacons will stop measuring
relative distances and will be ready to measure distance from the mobile beacon(s)
- Turn on and wake up the mobile beacon following the same steps as with the
stationary beacon: https://youtu.be/A4aRsjH2-_E
- If you see on the devices’ panel in the Dashboard that the beacon is colored
orange, it means there are some differences in some of the settings between
beacons. For example, some sensors may be off or some ultrasonic or radio
settings may be different. You can change the settings for sensors manually by
clicking on the panel on the upper right corner of the Dashboard to change the cells
from gray to green to turn on sensor. It is recommended that the default settings on
all beacons and the modem be used if this is your first time using the system
- After you freeze the map of stationary beacons, wake up the mobile beacon. After
it wakes up, it will be traceable in 5-7 seconds
- The system is now fully operational