Operation Manual

16
5. Setting up the system
5.1 First setup of your device
The steps below describe the very first time you set up of the system:
- Unpack the system. Watch the help video: https://youtu.be/sOce7B2_6Sk
- Check that your boards are charged; see that all switches on the beacons are
in the correct position (Power = ON; DFU = OFF). See the paragraph DIP
switch modes
- Press the RESET button on each beacon. If LED 2 is not blinking, it means
your board is turned off or discharged. Check the position of the DIP switch
again or charge the beacon via USB