Manual

84
4.6 Starter Set Industrial-NIA-01
The steps below describe the first set up of the system.
This is a Non-Inverse Architecture. You can find the description and comparison of
architectures here.
Pay attention: Industrial beacons have different HW and SW from HW v4.9. It
has different connectors, reset and DFU activation. Read more on Industrial
beacon page.
Industrial beacons have no battery, use power supply cable.
Use Industrial beacon’s SW for Industrial beacons, v4.9 for v4.9.
4.6.1 Unpack the system. Take a look at the similar unpacking video of HW
v4.9. They are different, but have some similar basics:
https://youtu.be/sOce7B2_6Sk
4.6.2 You do not have to charge Industrial beacons; they have no battery
4.6.3 You do not have to turn it on - Industrial beacons are permanently ON
4.6.4 Download SW Pack
4.6.5 Update all the beacons:
‒ Run the Dashboard and update the SW for all beacons and
modem using Dashboard => Firmware => Choose the file =>
Program
‒ If you see the message “Not found modem connection to
computer through USB” in the Dashboard or your PC does not
recognize beacons/modem, it usually means that the STM32
driver is not installed. To install the driver, download it with link