Manual

52
4.2 Starter Set HW v4.9
The steps below describe the very first time you set up of the system. Beacons HW
v4.9 and modem required.
4.2.1 Unpack the system. Watch the help video:
https://youtu.be/sOce7B2_6Sk
4.2.2 Charge all the beacons using USB cable. Full charging takes about 1-2
hours
4.2.3 Turn the beacons on: Place DIP switches as shown on the picture below
4.2.4 Download SW Pack
4.2.5 Update all the beacons (HEX programming):
‒ Run the Dashboard and update the SW for all beacons and
modem using Dashboard => Firmware => Choose the file =>
Program
‒ If you see the message “Not found modem connection to
computer through USB” in the Dashboard or your PC does not
recognize beacons/modem, it usually means that the STM32
driver is not installed. To install the driver, download it with link
at top window in the Dashboard and run the installation file, then
click on the link under and install the driver
Ensure that:
(c) You are programming the modem’s SW to the modem
and the beacon’s SW to the beacon
(d) You are using SW for HW v4.9, if you have HW v4.9;
and you have the SW from the same SW pack, i.e., the
Dashboard SW, modem SW, and beacon SW must be
from the same SW pack. Don’t mix SW releases