Manual

98
6.4.24. If you see in the table some empty cells or marked yellow/red, it is an
indication that distances between Some beacons are measured
inconsistently or not measured at all. Try to re-position them because usually
there is an obstruction of some sort in the between the beacons. If you have
any problems – check Table of distances chapter
6.4.25. Make a service zone, clicking on the map with Shift + Left Click. See
Submaps chapter for more details
6.4.26. Freeze the map by clicking the button. Stationary beacons will stop
measuring relative distances and will be ready to measure distance from the
mobile beacon(s)
6.4.27. Turn on and wake up the mobile beacon following the same steps as with
the stationary beacon. More details in our video: Demo: converting beacon to
mobile beacon ("hedgehog")
6.4.28. If you see on the devices’ panel in the Dashboard that the beacon is
colored orange, it means there are some differences in some of the settings
between beacons. For example, some sensors may be off or some ultrasonic
or radio settings may be different. You can change the settings for sensors
manually by clicking on the panel on the upper right corner of the Dashboard
to change the cells from gray to green to turn on sensor. It is recommended
that the default settings on all beacons and the modem are used if this is your
first time using the system.
6.4.29. After you freeze the map of stationary beacons, wake up the mobile
beacon. After it wakes up, it will be traceable within 5-7 seconds.