Manual

Side view of 2D configuration:

Top view of 2D configuration:

6.4.11. Connect the modem/router via USB to a Windows PC with the Dashboard

installed

6.4.12. Run the Dashboard. In the left corner of the Dashboard, the modem should

be shown as connected

6.4.13. Wake up all beacons by selecting them on the Dashboard panel

Only 4 stationary beacons may be in 1 submap. If you wake up more beacons,

create a new submap for them or it won’t be displayed on the map and in the

table of distances

6.4.14. It may take up to 7-10 seconds for the beacons to wake up

6.4.15. Notice, that if the modem is not active and is not powered, the beacons will

go into sleep mode automatically after 1 minute

6.4.16. The system may run the frequency search, if it is the very first time you are

waking up the beacons. If this step does not work, disconnect the modem and

connect that beacon again via USB. Press the DEFAULT button in the

Dashboard and the Read All button to make sure that the radio settings are the

default ones

6.4.17. Check that the radio settings on the modem and the radio settings on the

beacon are the same

Stationary beacon

Mobile beacon

Modem

beacon

≈6-10m

≈4-6m