Manual

95
6.4.5.22. Modem will go to DFU mode. Press UPGRADE button in the DfuSe
program
6.4.5.23. After a couple of seconds, the DFU will be uploaded to the modem. Make
sure it takes 1-3 seconds and does not happen immediately. Otherwise,
the SW has not been uploaded correctly. If the DFU appears to upload
immediately, check the "Choose" button you used or change the version
of DfuSe SW to a different one
6.4.5.24. Disconnect the short circuit
6.4.5.25. Start the Dashboard and press RESET button
6.4.5.26. If you experience difficulties in DFU programming, please try the
following:
6.4.5.27. Use a different computer with a different version of Windows or another
operating system
6.4.5.28. Install a different DfuSe version (whichever works best with your
Windows)
If you have uploaded the latest firmware for all the boards, you can start to activate the
system:
6.4.6. While the beacon or modem is connected to the Dashboard, click the
DEFAULT button on the Dashboard to upload the default settings
6.4.7. Write down the beacon’s address for future use or change the address at
your convenience as shown here. Beacons addresses should not be
repeated.
6.4.8. Press the RESET button on your beacons and modem after programming
6.4.9. After programming devices with the latest software, the modem and beacons
are ready for use
6.4.10. Place the stationary beacons high on the walls vertically in a way that will
provide optimal ultrasonic coverage. Write down the beacon’s height for future
change in the settings. The help video on installation can be found here -
https://youtu.be/WY0HkLzmjys