Manual

93
If SW flashed SUCCESSFULLY, MOVE DIRECTLY TO 4.2.6. If you have some
problems with HEX programming, use DFU programming:
DFU programming or SW uploading is used when HEX SW uploading in the Dashboard
cannot be used. For example, when you are updating from a very old SW version or when
the SW includes major changes to the system and the only possible way to update the SW
is via DFU programming
6.4.5.1. After the DFU SW upgrade, future SW upgrades can be done in a regular
manner via the Dashboard
6.4.5.2. To start programming, move the beacon’s DIP switch to the DFU
programming mode, as described in the paragraph on DIP switch modes
6.4.5.3. Download the latest SW package, unzip it, and select the proper version
of the SW for your HW and for your frequency variant. Remember that
for DFU programming, you should use DFU SW (DfuSe), not
Dashboard’s .hex file
6.4.5.4. Download DfuSe
6.4.5.5. Here you will find different versions of DfuSe. v3.0.5 or v3.0.6, whichever
works the best for your Windows: DfuSe v3.0.5 or DfuSe v3.0.6
6.4.5.6. DFU Programming:
6.4.5.7. Put DIP switch into Power = ON, DFU = ON
6.4.5.8. Connect the beacon via USB to your PC
6.4.5.9. Run DfuSe
6.4.5.10. Press the RESET button on your beacon
6.4.5.11. In the upper left corner of the DfuSe program, you will see a device
connected in the DFU mode