Manual

92
6.4. Starter Set HW v4.9
The steps below describe the very first time you set up of the system in NIA. Beacons
HW v4.9 with the same frequencies and Modem HW v4.9 required.
This is Non-Inverse Architecture. Use NIA Software ONLY
6.4.1. Unpack the system. Watch the help video: https://youtu.be/sOce7B2_6Sk
6.4.2. Charge all the beacons using USB cable. Full charging takes about 1-2 hours
6.4.3. Turn the beacons on: Place DIP switches as shown on the picture below
6.4.4. Download SW Pack
6.4.5. Update all the beacons (HEX programming):
- Run the Dashboard and update the SW for all beacons and modem using Dashboard =>
Firmware => Choose the file => Program
- If you see the message “Not found modem connection to computer through USB” in the
Dashboard or your PC does not recognize beacons/modem, it usually means that the
STM32 driver is not installed. To install the driver, download it with link at top window in the
Dashboard and run the installation file, then click on the link under and install the driver
Ensure that:
- You are programming the modem’s SW to the modem and the beacon’s SW to the beacon
- You are using SW for HW v4.9, if you have HW v4.9; and you have the SW from the same
SW pack, i.e., the Dashboard SW, modem SW, and beacon SW must be from the same
SW pack. Don’t mix SW releases
DIP switches
Reset
Reset button (on side)