Manual

81
6.3. Starter Set Super-MP-3D (NIA and IA)
The steps below describe the very first time you set up the system in NIA.
Super-Beacons and Modem HW v5.1 required.
This Set can bused in IA and NIA. Use NIA Software for Non-Inverse Architecture and
IA Software for Inverse Architecture.
6.3.1. Unpack the system. Look at a similar unpacking video of HW v4.9. The
videos have certain differences but the basic are the same: Unpacking
Marvelmind Precise (+-2cm) Indoor "GPS"
6.3.2. Charge all the beacons using USB cable. Full charging takes about 1-2 hours
6.3.3. Turn the beacons on: Place DIP switches as shown on the picture below
6.3.4. Download SW Pack
6.3.5. Update all the beacons (HEX programming):
6.3.6. Run the Dashboard and update the SW for all beacons and modem using
Dashboard => Firmware => Choose the file => Program
6.3.7. If you see the message “Not found modem connection to computer through
USB” in the Dashboard or your PC does not recognize beacons/modem, it
usually means that the STM32 driver is not installed. To install the driver,
download it with link at top window in the Dashboard and run the installation
file, then click on the link under and install the driver
Reset button
DIP switches