Manual

78
8. Exit from the DFU mode:
- For regular and non-Industrial versions of beacons – switch DIP
switches into positions shown on the picture (Left – down, right – up)
and press the Reset button – device will exit from DFU mode
- For Industrial versions of beacon and Super-Modem – remove one
from the DFU switch side, and attach for 1 second the second magnet
to the Reset side of the device – device will exit from DFU mode
- For Modem HW v5.1 and Modem HW v4.9 – shot circuit DFU mode
pins and press the Reset button – device will go into DFU mode
9. Start the Dashboard, left device connected to the PC via USB (Do not forget
to power Industrial versions of beacon and Super-Modem – they do not have
internal battery), device should appear in the Dashboard.
10. Check SW on the beacon afterwards.
11. Everything should be OK with SW now. DFU programming is complete.