Manual

77
DFU Programming process:
1. Enter device into DFU Mode:
- For regular and non-Industrial versions of beacons – switch DIP
switches into positions shown on the picture (both up) and press the
Reset button – device will go into DFU mode
- For Industrial versions of beacon and Super-Modem – attach one
magnet to the DFU switch side, and attach for 1 second the second
magnet to the Reset side of the device – device will go into DFU mode
(Do not forget to power Industrial versions of beacon and Super-
Modem – they do not have internal battery)
- For Modem HW v5.1 and Modem HW v4.9 – short DFU mode pins and
press the Reset button – device will go into DFU mode
2. Connect the device via USB to your PC (Do not forget to power Industrial
versions of beacon and Super-Modem – they do not have internal battery).
3. Run DfuSe (Choose whichever works the best for your Windows: DfuSe
v3.0.4 or DfuSe v.3.0.5.
4. In the upper left corner of the DfuSe program, you will see a device connected
in the DFU mode (If not – reenter device into DFU mode).
5. Choose the DFU driver (file) for the beacon.
6. Click the UPGRADE button.
7. After a couple of seconds, the DFU will be uploaded to the beacon. Make
sure it takes 1–3 seconds and does not happen instantly. Otherwise, the SW
has not been uploaded correctly. If the DFU appears to upload immediately,
check the "Choose" button you used or change the version of DfuSe SW you
selected.