Manual

71
5.2. SW update (USB/Radio/DFU)
This chapter describes three general ways of SW update. Regular - using USB
connection, or Radio connection. And SW update for special cases (if SW version gap
is very big, or regular SW update do not work) – DFU Programming.
5.2.1. SW update via USB
Usually, SW update via USB is used for the very first time you starting up the system. It
allows you to make an update up to actual SW version very quickly before the system
deployment.
Pros: Quick SW update per beacon.
Cons: All the devices should be connected to the PC via USB cable. If you already
deployed the system, you will need to unmount it.
How to:
- Launch the Dashboard
- Make sure that the beacon is on
- Connect beacon to your PC via USB cable
- When beacon connected to the Dashboard, go to “Firmware” → “Upload firmware”