Manual

65
5. SW settings descriptions
5.1. Super-Modem’s SW update and configuration description
5.1.1. Super-Modem’s SW update
Do not disassemble the Super-Modem before you check the SW version installed. First of all,
check if the SW version of your Super-Modem is up to date (Latest version on the Marvelmind
Downloads page). If not – update the software as described below
Marvelmind Super-Modem software consists of two parts:
- Low level firmware
- High level software for integrated Raspberry Pi single-board computer
Low level firmware is placed in general software package with all Marvelmind software in
‘Super-Modem’ folder. This firmware can be updated via dashboard (hex file) or via DFU
(dfu file) like other firmware in the package. Please refer to Operating Manual for details of
updating software via dashboard or dfu.
High level software is located on micro-SD card inserted in the Raspberry Pi single-board
computer inside Super-Modem. To update this software, you should write on this micro-SD
card the image of micro-SD card with updated software. You can download the image on
downloads page (https://marvelmind.com/download/). The image is placed in archive
separately from general software package because its size is pretty large (archive is about
1.5 - 2 GB).
Micro-SD card location