Manual

203
9.17.2. If you want to pair beacons via Radio do not connect beacons via anything
and change “Communication in pair” on “via radio” later after point 7.12.6
(Note: If the distance between beacons is less than 1 meter it would be
probably necessary to change in “Parameters of radio” the parameter “Power
of TX” for less value. Otherwise, the signal probably would be too strong). Only
applicable to NIA
9.17.3. Wake up stationary beacons and freeze the map
9.17.4. Wake up two hedgehogs which were pre-installed on robot/copter/drone
9.17.5. Choose one beacon and go to “Pairing mode” parameter and activate
9.17.6. Write the “Address of paired beacon”, means number of the beacon,
current selected hedgehog is paired with
9.17.7. Now choose location against center in parameters relatively the second
beacon
9.17.8. Go to “Base of the pair” parameter and write actual distance between
paired hedgehogs. Do the same for 2
nd
hedgehog