Manual

188
9.12. Submap Settings
Every submap has its own settings.
For example, to correspond your submap to a certain floor you need to adjust the height:
- Left click on the submap icon to open the settings-
- Change Submap Z shift value
Which beacon will have origin (0; 0; 0) coordinates
Addresses of beacons which are building this submap
3D (X; Y; Z) Tracking mode for this submap
To enable “Vertical submap for stable Z” configuration
Height of hedges for “Vertical submap for stable Z”
Maximum measuring distance limitation mode
Maximum measuring distance between stationary and mobile
Service zone thickness value in meters
Submap X shift value in meters
Submap Y shift value in meters
Submap Z shift value in meters
Submap rotation value in degrees
Plane rotation, X value (“Vertical submaps for stable Z”)
Plane rotation, Y value (“Vertical submaps for stable Z”)
Plane rotation, Z value (“Vertical submaps for stable Z”)
Visibility of stationary beacons (Only displaying setting)
Visibility of service zones (Only displaying setting)