Manual

136
7.9.2. Beacon’s settings
7.9.2.1. Basic settings
Unique CPU ID
Enable for mobile beacon and disable for stationary beacon
TBD
Measured voltage of internal battery
Time from the latest reset
Firmware version of device (beacon or modem)
Strength of the radio signal from modem to this beacon, i.e.
how the beacon “hears” the modem over radio. Keep below -
25dBm and above -80dBm to avoid losses of packets. Lower
end depends on radio profile and interference
Strength of the radio signal from this beacon to the modem, i.e.
how the modem “hears” the beacon over radio. Keep below -
25dBm and above -80dBm to avoid losses of packets. Lower
end depends on radio profile and interference
TBD
Real carrier frequency
Select radio frequency band according to your HW:
433MHz or 915MHz