Manual

131
Logical address of the device. Keep 2..255 for beacons.
Address
Pre-selected channel – one of the radio channels for
communication between modem and beacons
TBD
Averaging between location update measurements. More
value – less location jitter, but higher latency
Filter of distances (as opposed to filter of locations). More –
better filtering, but may be too conservative and “kill” good
measurements
Keep Enabled normally. Switch to cm for backward
compatibility
TBD
If map is frozen, new beacons will be accepted in the map,
if enabled
Measured temperature of the processor’s crystal
TBD