Manual

117
6.6.23.3. Now, enter measured (measure it with laser distance meter or so) value.
That values would not change until you unfreeze or clear it. Even if
beacons had been moved, distance would stay. Be careful with frozen
cells because a small mistake can cause a huge impact on your tracking
6.6.23.4. Repeat for all cells
6.6.24. Freeze the map by clicking the button. Stationary beacons will stop
measuring relative distances and will be ready to measure distance from the
mobile beacon(s)
6.6.25. Turn on and wake up the mobile beacon following the same steps as with
the stationary beacon: https://youtu.be/A4aRsjH2-_E
6.6.26. If you see on the devices’ panel in the Dashboard that the beacon is
colored orange, it means there are some differences in some of the settings
between beacons. For example, some sensors may be off or some ultrasonic
or radio settings may be different. You can change the settings for sensors
manually by clicking on the panel on the upper right corner of the Dashboard
to change the cells from gray to green to turn on sensor. It is recommended
that the default settings on all beacons and the modem be used if this is your
first time using the system
6.6.27. After you freeze the map of stationary beacons, wake up the mobile
beacon. After it wakes up, it will be traceable within 5-7 seconds