Manual

115
Top view:
6.6.12. Connect the modem/router via USB to a Windows PC with the
Dashboard installed
6.6.13. Run the Dashboard. In the left corner of the Dashboard, the modem
should be shown as connected
6.6.14. Wake up all beacons by clicking on the buttons in the Dashboard on the
panel
6.6.15. It may take up to 7-10 seconds for the beacons to wake up
6.6.16. If the modem is not active and is not powered, the beacons will go into
sleep mode automatically after 1 minute
6.6.17. The system may run the frequency search, if it is the very first time you are
waking up the beacons. If this step does not work, disconnect the modem and
connect that beacon again via USB. Press the DEFAULT button in the
Dashboard and the Read All button to make sure that the radio settings are the
default ones
6.6.18. Check that the radio settings on the modem and the radio settings on the
beacon are the same
6.6.19. Now you can check RSSI, voltage, ultrasonic filter settings, etc. on the
panel on the right corner of the Dashboard
≈6-10m
≈4-6m