Manual

109
6.6. Starter Set Industrial-NIA-01
The steps below describe the first set up of the system.
This is a Non-Inverse Architecture. You can find the description and comparison of
architectures here.
Pay attention: Industrial beacons have different HW and SW from HW v4.9. It has
different connectors, reset and DFU activation. Read more on Industrial beacon page.
Industrial beacons have no battery, use power supply cable.
Use Industrial beacon’s SW for Industrial beacons, v4.9 for v4.9.
Do not disassemble the Industrial beacons. Otherwise, warranty will be lost
Version 3 of Industrial RX (from April 2022) supports ONLY +5V power supply. Don’t
use +12V power supply converter for this version, it will burn the beacon!
Version 3 doesn’t have UART RX, but now is possible to use Interface connector as a
power supply. For this version.
6.6.1. Unpack the system. Take a look at the similar unpacking video of HW v4.9.
They are different, but have some similar basics:
https://youtu.be/sOce7B2_6Sk
6.6.2. You do not have to charge Industrial beacons; they have no battery
6.6.3. You do not have to turn it on - Industrial beacons are permanently ON
6.6.4. Download SW Pack
6.6.5. Update all the beacons:
Magnetic DFU switch side
Magnetic Reset side