Manual

102
6.5.5.7. Connect the beacon via USB to your PC
6.5.5.8. Run DfuSe
6.5.5.9. Press the RESET button on your beacon
6.5.5.10. In the upper left corner of the DfuSe program, you will see a device
connected in the DFU mode
6.5.5.11. Choose the DFU driver (file) for the beacon
6.5.5.12. Click the UPGRADE button
6.5.5.13. After a couple of seconds, the DFU will be uploaded to the beacon. Make
sure it takes 1–3 seconds and does not happen instantly. Otherwise, the
SW has not been uploaded correctly. If the DFU appears to upload
immediately, check the "Choose" button you used or change the version
of DfuSe SW you selected
6.5.5.14. Move the DIP switch into Power = ON, DFU = OFF
6.5.5.15. Start the Dashboard and press the RESET button on the beacon
6.5.5.16. Check SW on the beacon afterwards
6.5.5.17. Everything should be OK with SW now. DFU programming is complete
Follow the same scenario for the modem:
- Here is the link for the modem DFU programming. The
steps are similar to those for beacon DFU programming