Manual

Step 4.1: If something is wrong
18
- Please, re-check the previous steps and Operating Manual and our YouTube channel. Try also:
- Check that only correct sensors (RX1-RX5) are enabled
- Fly farther from stationary beacons, i.e. place them 15m apart and fly only within the central 5 meters spot, etc.
- If everything is really correctly done, then, probably, the copter is simply too noisy, range is too big or something more fundamental:
- Reduce the range between beacons to increase signal/noise ratio
- Use less noisy drone or perform other similar operations to increase signal/noise ratio