Datasheet

103
6.5.5.18. After uploading DFU driver by DfuSe short circuit pins as shown on the
picture and press Reset button
6.5.5.19. Modem will go to DFU mode. Press UPGRADE button in the DfuSe
program
6.5.5.20. After a couple of seconds, the DFU will be uploaded to the modem. Make
sure it takes 1-3 seconds and does not happen instantly. Otherwise, the
SW has not been uploaded correctly. If the DFU appears to upload
immediately, check the "Choose" button you used or change the version
of DfuSe SW to a different one
6.5.5.21. Disconnect the short circuit
6.5.5.22. Start the Dashboard and press RESET button
If you have uploaded the latest firmware for all of the boards, you can start to activate the
system:
6.5.6. While the beacon or modem is connected to the Dashboard, click the
DEFAULT button on the Dashboard to upload the default settings