Data Sheet

98
5.1.24 If the map does not form well, check the table of distances in the left
corner of the Dashboard. The cells must be colored in white; it means the
distances between stationary beacons are measured correctly
5.1.25 If you see in the table some empty cells or marked yellow/red, it is an
indication that distances between Some beacons are measured
inconsistently or not measured at all. Try to re-position them because
usually there is an obstruction of some sort in the between the beacons.
If you have any problems – check Table of distances chapter
5.1.26 Make a service zone, clicking on the map with Shift+Left Mouse Button.
See Submaps chapter for more details
5.1.27 Freeze submap and by clicking the button. Stationary beacons will stop
measuring relative distances and will be ready to measure distance from
the mobile beacon(s).
5.1.28 Turn on and wake up the mobile beacon following the same steps as with
the stationary beacon: https://youtu.be/A4aRsjH2-_E
5.1.29 If you see on the devices’ panel in the Dashboard that the beacon is
colored orange, it means there are some differences in some of the
settings between beacons. For example, some sensors may be off or
some ultrasonic or radio settings may be different. You can change the
settings for sensors manually by clicking on the panel on the upper right
corner of the Dashboard to change the cells from gray to green to turn
on sensor. It is recommended that the default settings on all beacons and
the modem be used if this is your first time using the system.
5.1.30 After you freeze the map of stationary beacons, wake up the mobile
beacon. After it wakes up, it will be traceable in 5-7 seconds.
freeze submap