Data Sheet

5. Setting up the system (IA)

5.1 Starter Set Super-MP-3D

The steps below describe the very first time you set up of the system. Super-Beacons

with different ultrasonic frequencies and modem required.

This is Inverse Architecture. Super-Beacons should have different

frequencies. Use IA Software ONLY.

You can’t just switch Super-Beacon to another frequency, it is HW depended

Ultrasonic can't be changed to default. You must check the frequency on the

white sticker

5.1.1 Unpack the system. Take a look at the similar unpacking video of HW

v4.9. They are different, but have some similar basics:

https://youtu.be/sOce7B2_6Sk

5.1.2 Charge all the beacons using USB cable. Full charging takes about 2-4

hours

5.1.3 Turn the beacons on: Place DIP switches as shown on the picture below

5.1.4 Download SW Pack

5.1.5 Update all the beacons

‒ You need Inverse Architecture SW (go to

marvelmind_SW_xxx_xx_xx\Software_ia)