Data Sheet

4.6.11 Connect the modem/router via USB to a Windows PC with the

Dashboard installed

4.6.12 Run the Dashboard. In the left corner of the Dashboard, the modem

should be shown as connected

4.6.13 Wake up all beacons by clicking on the buttons in the Dashboard on

the panel

4.6.14 It may take up to 7-10 seconds for the beacons to wake up

4.6.15 Notice, that if the modem is not active and is not powered, the

beacons will go into sleep mode automatically after 1 minute

4.6.16 The system may run the frequency search, if it is the very first time

you are waking up the beacons. If this step does not work,

disconnect the modem and connect that beacon again via USB.

Press the DEFAULT button in the Dashboard and the Read All

button to make sure that the radio settings are the default ones

4.6.17 Check that the radio settings on the modem and the radio settings

on the beacon are the same

4.6.18 Now you can check RSSI, voltage, ultrasonic filter settings, etc. on

the panel on the right corner of the Dashboard

4.6.19 Enter the height of stationary beacons. Choose beacon in the list

and enter height value

4.6.20 Enter the height for mobile beacon if you use 2D mode