Data Sheet

60
4.3 Starter Set NIA-01-3D
The steps below describe the very first time you set up the system. Mini-RX, HW
v4.9 beacons and modem required.
Mini-RX has different HW and SW from HW v4.9. Use Mini-RX SW for Mini-RX
beacons, HW v4.9’s SW for HW v4.9
4.3.1 Unpack the system. Look at a similar unpacking video of HW v4.9. The
videos have certain differences but the basic are the same:
https://youtu.be/sOce7B2_6Sk
4.3.2 Charge all the beacons using USB cable. Full charging takes about 1-2
hours
4.3.3 Turn the beacons on (To turn Mini-RXs on, carefully disassemble its
housing and find DIP switches inside. It is necessary only for the first
start. You can also turn it off with switches for long-term storage): Place
DIP switches as shown on the picture below
4.3.4 Download SW Pack
4.3.5 Update all the beacons:
‒ Run the Dashboard and update the SW for all beacons and
modem using Dashboard => Firmware => Choose the file =>
Program
‒ If you see the message “Not found modem connection to
computer through USB” in the Dashboard or your PC does not
recognize beacons/modem, it usually means that the STM32
driver is not installed. To install the driver, download it through
the link in the top window in the Dashboard and run the
installation file, then click on the link under and install the driver
Make sure that that:
a. You are programming the modem’s SW to the modem and
the beacon’s SW to the beacon