User's Manual
Table Of Contents
- Table of Content
- _
- _
- _
- _
- _
- _
- _
- _
- _
- How to: Setup of an Ad-Hoc network using UAY-MMC85M wireless cards
Setup of an Ad-Hoc network using UAY-
MMC85M wireless cards
Marvell AppNote
AN -xxxx
Page 45 Marvell
®
Proprietary. V 1.0
APPENDIX B
Setting up UAY-MMC85M
This section provides step by step procedure on how to install the UAY-MMC85M
driver, the Marvell Client Configuration Utility (Marvell GUI) and the settings required
on the Marvell GUI in order to set up the UAY-MMC85M to operate in Ad-Hoc mode.
The UAY-MMC85M apparatus consists of a PCIe card (UAY-MMC85M) and a PCIe
extender adapter board. The UAY-MMC85M is a PCIe card. This card is plugged into
the PCMCIA slot with PCIe interface of the laptop using a PCIe-to-PCIe adapter
extender card. The figure below shows the assembly.
1] UAY-MMC85M Driver Installation
This section explains how to install both the UAY-MMC85M client card and the driver
for Marvell high throughput client cards in a client card slot of a Windows XP based PC
computer. The client card driver must be installed before installing the Marvell
Configuration Utility.
1.1 Installing the Client Card
To install the client card:
1. Turn the computer off.
2. Insert the extender adapter (connector end toward the computer) into an available
client card slot
3. Turn the computer on.
1.2 Installing the Windows XP driver
When the computer detects the client card extender, the Found Hew Hardware Wizard
dialog box is displayed.