User's Manual
Table Of Contents
- Table of Content
- _
- _
- _
- _
- _
- _
- _
- _
- _
- How to: Setup of an Ad-Hoc network using UAY-MMC85M wireless cards
Setup of an Ad-Hoc network using UAY-
MMC85M wireless cards
Marvell AppNote
AN -xxxx
Page 44 Marvell
®
Proprietary. V 1.0
APPENDIX A
Federal Communications Commission (FCC) Compliance
This device complies with Part 15 of the FCC Rules and Regulations. Operation is
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio-frequency energy and, if not installed
and used in accordance with these instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in any
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to correct the interference by one of more of the following measures:
1) Reorient the antenna.
2) Increase the separation between the affected equipment and the unit.
3) Connect the affected equipment to a power outlet on a different circuit from that
which the receiver is connected to.
4) Consult the dealer and/or experienced radio/TV technician for help.
FCC ID: UAY-MMC85M
MODEL: MC-85
IMPORTANT NOTE:
Intentional or unintentional changes or modifications must not be made unless under the
express consent of the party responsible for compliance. Any such modifications could
void the user’s authority to operate the equipment and will void the manufacturer’s
warranty. To comply with FCC RF exposure requirements, the following antenna
installation and device operating configurations must be satisfied. The antenna for this
unit must have a separation distance of at least 20 cm from all persons. Furthermore, it
must not be co-located or operating in conjunction with any other antenna or transmitter.