User's Manual
Table Of Contents
- Table of Content
- _
- _
- _
- _
- _
- _
- _
- _
- _
- How to: Setup of an Ad-Hoc network using UAY-MMC85M wireless cards
Setup of an Ad-Hoc network using UAY-
MMC85M wireless cards
Marvell AppNote
AN -xxxx
Page 27 Marvell
®
Proprietary. V 1.0
2.3] Ad-Hoc Setup bring up
2.3.1] Using UAY-MMC85M switch mode driver
The following section provides steps to bring up the setup to test the master for radar
detection purposes. Please remember to use the test mode driver for these detections. In
case of finding the channel move time, the closing time, it is advised to use the channel
switch mode driver. The procedure below describes the steps to change the drivers.
1. On the Master laptop, double click on the Dbgview.exe icon to open it.
2. Double click on the Marvell GUI icon to open the GUI window.
3. Plug in the UAY-MMC85M master PCIe extender assembly in the laptop. The
laptop screen should look like below.