Specifications

MV01-94000-00

Rev C

2. Using a 3mm Allen Wrench (Key), loosen the three bolts attaching the hexagonal

tube to the frame.

3. Slide the hexagonal tube to the desired position.

4. WARNING: Use “Threadlocker Loctite 242” to lock threaded fasteners against

vibration loosening. Threadlocker Loctite 242 allows for fasteners to be removed

with hand tools. Replace and tighten the three bolts. (Tighten to six newton meters

(Nm) or five foot pounds). Failure to heed these warnings could cause damage to

your wheelchair, injury to yourself, a fall, a tip-over and/or loss of control, causing

severe injury to yourself or others.

5. Re-attach the Caster Wing (See instructions entitled “Putting on the Caster Wing”)

Adjusting Height

1. Make sure you have a Marvel Wheelchair Seat Attachment Kit (Part # FM-1-5)

2. Using a 5mm Allen Wrench (Key), remove, the four bolts (two on each side)

attaching the shock to the tracks on the seat section.