Installation Operation and Maintenance Instructions Combination Refrigerator / Freezer 6CRF 8CRF
CONTENTS Unpacking your refrigerator ................................................. Removing the packaging ..................................................... Warranty registration ......................................................... Installing your refrigerator ................................................... Select location .................................................................... Cabinet clearances ............................................................. Leveling legs .......
UNPACKING YOUR REFRIGERATOR Remove Packaging Warranty Registration Your refrigerator has been packed for shipment with all parts that could be damaged by movement securely fastened. Cut the banding material at the bottom of the carton, unfold the carton at the bottom and remove the carton from the appliance. Remove the plastic bag, styrofoam corner posts, and any tape holding the door closed and internal components in place.
INSTALLING YOUR REFRIGERATOR Select Location Leveling Legs The proper location will ensure peak performance of your appliance. We recommend a location where the unit will be out of direct sunlight and away from heat sources. To assure your product performs to specifications the recommended installation location temperature range is from 65 to 90°F (18 to 32°C).
GROUNDING METHOD AND ELECTRICAL REQUIREMENTS • • Do not splash or spray water from a hose on the refrigerator! Doing so may cause an electrical shock, which may result in severe injury or death. This unit should not, under any circumstances, be installed to an un-grounded electrical supply. Grounding Method This product is factory equipped with a power supply cord that has a three-pronged, grounded plug.
HANDLE INSTALLATION AND DOOR ALIGNMENT PROCEDURE Handle Installation (Solid Door Models) 1. 2. Door Alignment Procedure Remove the handle, (2) screws, and 5/32” hex key wrench from the bag shipped inside the cabinet. Locate handle opposite the hinges and secure in place using the (2) screws and the hex key wrench. (See Figure 5). The door should be parallel to the sides and top of the refrigerator.
DIMENSIONS FOR 6CRF WITH SOLID DOOR 47-3/32” (119.61cm) 24-7/8” (63.20cm) 25-11/32” (64.36cm) 24-3/32” (64.19cm) 23-7/8” (60.7CM) 33-3/4” to 34-3/4” (85.7 to 88.3cm) 3” to 4” (7.6 to 10.2cm) 22” (55.9cm) ROUGH IN OPENING FOR 6CRF WITH SOLID DOOR Electrical Requirements: Electrical Requirements: A 115 volt, 15 amp dedicated circuit is required. A 3 prong grounded receptacle is required. Power outlet can be located in the back wall behind unit.
DIMENSIONS FOR 6CRF WITH GLASS DOOR 46-7/8” (119.08cm) 25-19/32” (65.0cm) 26-1/32” (66.12cm) 24-3/32” (61.19cm) 23-7/8” (60.7CM) 33-3/4” to 34-3/4” (85.7 to 88.3cm) 3” to 4” (7.6 to 10.2cm) 22” (55.9cm) ROUGH IN OPENING FOR 6CRF WITH GLASS DOOR Electrical Requirements: Electrical Requirements: A 115 volt, 15 amp dedicated circuit is required. A 3 prong grounded receptacle is required. Power outlet can be located in the back wall behind unit.
DIMENSIONS FOR 8CRF WITH SOLID DOOR 52-15/16” (134.47cm) 30-7/8” (78.44cm) 25-11/32” (64.36cm) 24-3/32” (61.19cm) 29-7/8” (75.9CM) 33-3/4” to 34-3/4” (85.7 to 88.3cm) 3” to 4” (7.6 to 10.2cm) 22” (55.9cm) ROUGH IN OPENING FOR 8CRF WITH SOLID DOOR Electrical Requirements: Electrical Requirements: A 115 volt, 15 amp dedicated circuit is required. A 3 prong grounded receptacle is required. ** 34” to 35” (86.36 to 88.9cm) Power outlet can be located in the back wall behind unit.
ADJUSTING THE TEMPERATURE CONTROL Adjusting the temperature control After plugging in the units power cord set the temperature control midway between the numbers. After 2 hours adjust to the temperature that suits you. The higher the number you select, the cooler the temperature. (See Figure 7). The temperature control knob is located at the bottom, front of the cabinet, just behind the square opening near the middle of the grille.
ENERGY SAVING TIPS Energy Saving Tips The following suggestions will minimize the cost of operating your refrigeration appliance. 1. Do not install your appliance next to a hot appliance, (ovens, glassware washers, etc.). heating air duct, or other heat sources. 2. Install product out of direct sunlight. 3. Assure the toe grille vents at front of unit beneath door are not obstructed and kept clean to allow ventilation for the refrigeration system to expel heat. 4.
CARE AND CLEANING Cleaning instructions Condenser The condenser underneath the cabinet does not require frequent cleaning; however, satisfactory cooling depends on adequate ventilation over this heat exchanger. It is recommended to annually clean the condenser by vacuuming and brushing. To access the condenser, the unit must be pulled out from the installation, and the lower machine compartment access cover removed. Disconnect the power cord before cleaning the condenser.
TROUBLESHOOTING YOUR REFRIGERATOR Before You Call for Service If the unit appears to be malfunctioning, read through this manual first. If the problem persists, check the troubleshooting guide below. Locate the problem in the guide and refer to the cause and its remedy before calling for service. The problem may be something very simple that can be solved without a service call. However, it may be required to contact your dealer or a qualified service technician.
OBTAINING SERVICE If Service is Required: • • • • • If the product is within the first year warranty period please call Marvel Customer Service at 800.223.3900 for directions on how to obtain warranty coverage in your area. If the product is outside the first year warranty period, Marvel Customer Service can provide recommendations of service centers in your area. A listing of authorized service centers is also available at www.marvelrefrigeration.com under the service and support section.
COMMERCIAL PRODUCT WARRANTY Marvel Refrigeration (Marvel) Limited Warranty ONE YEAR LIMITED PARTS & LABOR WARRANTY For one year from the date of original purchase, this warranty covers all parts and labor to repair or replace any part of the product that proves to be defective in materials or workmanship. For products installed and used for normal residential use, material cosmetic defects are included in this warranty, with coverage limited to 60 days from the date of original purchase.
www.marvelrefrigeration.com Marvel Refrigeration 1260 E. VanDeinse St. Greenville MI 48838 800.223.3900 41011887-EN Rev K 1/14/20 All specifications and product designs subject to change without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions, replacements or compensation for previously purchased products.