GE T TING STARTED QUICK REFERENCE GUIDE M ARVEL UNDERCOUNTER REFRIGERATION MODR224 MOFZ224 MORF224 T H E O R I G I N A L R E F R I G E R AT I O N E X P E R T S S I N C E 1 8 9 2
CONTENTS Contents: Important Safety Instructions Safety information ...............................................................2 Unpacking Your Appliance ................................................. 3 Installing your appliance ......................................................4 Electrical ..............................................................................5 Door Reversal .....................................................................6 Installing the anti-tip device ...........
UNPACKING YOUR APPLIANCE ! Warranty Registration WARNING It is important you send in your warranty registration card immediately after taking delivery of your appliance or you can register online at www.marvelrefrigeration.com. EXCESSIVE WEIGHT HAZARD Use two or more people to move product. Failure to do so can result in personal injury. The following information will be required when registering your appliance.
INSTALLING YOUR APPLIANCE Select Location The proper location will ensure peak performance of your appliance. We recommend a location where the unit will be out of direct sunlight and away from heat sources. To ensure your product performs to specifications, the recommended installation location temperature range is from 55 to 100°F (13 to 38°C). Front grille screws Cabinet Clearance Ventilation is required from the bottom front of the appliance. Keep this area open and clear of any obstructions.
ELECTRICAL Electrical Connection A grounded 115 volt, 15 amp dedicated circuit is required. This product is factory equipped with a power supply cord that has a three-pronged, grounded plug. It must be plugged into a mating grounding type receptacle in accordance with the National Electrical Code and applicable local codes and ordinances (see Figure 6). If the circuit does not have a grounding type receptacle, it is the responsibility and obligation of the customer to provide the proper power supply.
DOOR REVERSAL Door Reversing Instructions Tools Needed: • 1/8” Hex Key • 5/32” Hex Key • Phillips Screwdriver 1. Open door and remove Hinge Pin from the Upper Hinge using a 1/8” Hex Key tool (Fig. 6), making sure to steady the door Slowly remove the door from the Upper Hinge and lift to remove off the base Lower Hinge. 2. Using a Phillips Screwdriver, remove the 6 screws from both the Upper and Lower Hinges and save for later steps 3.
DOOR REVERSAL 6. Remove the Toe Kick from the door and attach it to the opposite side (Fig. 8). Figure 8 - Toe Kick Reversal 7. Reattach the Upper and Lower Hinges, and Hinge Brackets to opposite sides. Then install the door.
INSTALLING THE ANTI TIP DEVICE Anti-Tip Bracket WARNING ! • ALL APPLIANCES CAN TIP RESULTING IN INJURY. • INSTALL THE ANTI-TIP BRACKET PACKED WITH THE APPLIANCE. • FOLLOW THE INSTRUCTIONS BELOW 211⁄2" (54.6 cm) Leveling Leg Bottom View of Appliance Front of cabinet Anti-Tip Device ! Figure 12 WARNING If your appliance is not located under a counter top (free standing), you must use an anti-tip device installed as per these instructions.
USING YOUR ELECTRONIC CONTROL Figure 13 Electronic control Control Function Guide Function Command Notes ON/OFF Press and hold for 5 seconds. Unit will immediately turn ON or OFF. Adjust Temperature Press or and release. When the display is flashing, press or to adjust the set point temperature. Note: temperature displayed is the actual temperature inside unit. Toggle Between oF / oC Hold and for 5 seconds. The display will change units.
CARE AND CLEANING Outdoor Product Long-Term Storage / Winterization: 18. Do not place a cover on the unit, as this can trap condensation. 1. Time to Winterize, when the daily low ambient temperature is at or below 38°F (3.3°C). ! CAUTION After completion of the above, you may choose to store the unit indoors, although this is not required. Operation of the unit at ambient temperatures below the recommended Winterization temperature will void your warranty. 2. Turn unit off, (see page 10) 3.
STAINLESS STEEL MAINTENANCE AND ENERGY SAVING TIPS Background NOTE Stainless steel does not stain, corrode, or rust as easily as ordinary steel, but it is not stain or corrosion proof. Stainless steels can discolor or corrode if not maintained properly. finish. Stainless steel products should never be installed, or stored in close proximity to chlorine chemicals. Stainless steels differ from ordinary carbon steels by the amount of chromium present.
HOUSEHOLD PRODUCT WARRANTY Marvel Refrigeration (Marvel) Limited Warranty ONE YEAR LIMITED PARTS & LABOR WARRANTY For one year from the date of original purchase, this warranty covers all parts and labor to repair or replace any part of the product that proves to be defective in materials or workmanship. For products installed and used for normal residential use, material cosmetic defects are included in this warranty, with coverage limited to 60 days from the date of original purchase.
www.marvelrefrigeration.com Marvel Refrigeration 1260 E. Van Deinse St. Greenville MI 48838 616.754.5601 41016208 Rev A 3/16/21 All specifications and product designs subject to change without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions, replacements or compensation for previously purchased products.
