Panel Specification Sheet

ManualsBrandsMarvel ManualsCompact Refrigerators24 Inch Built-In Drawer Refrigerator with 5.0 Cu. Ft. Capacity, Adjustable Quick-Grip Divider, Dynamic Cooling Technology, Thermal-Efficient Cabinet, Sound-Buffering Design, Sabbath Mode, and ENERGY STAR® Certified: Solid Panel Ready

OWNERS GUIDE

MARVEL UNDERCOUNTER REFRIGERATION

THE ORIGINAL REFRIGERATION EXPERTS SINCE 1892

FOR MODEL # MLRE224

OWNER'S GUIDE

MARVEL UNDERCOUNTER REFRIGERATION

THE ORIGINAL REFRIGERATION EXPERTS SINCE 1892

FOR MODEL # MLDR224

Summary of content (7 pages)

PAGE 1
O WNERS G UIDE OWNER'S GUIDE MARVEL UNDERCOUNTER REFRIGERATION M ARVEL UNDERCOUNTER REFRIGERATION M LLD RR E2 2 4 F O R M O D E L ## M T H E O R I G I N A L R E F R I G E R AT I O N E X P E RT S S I N C E 1 8 9 2 THE ORIGINAL REFRIGERATION EXPERTS SINCE 1892
PAGE 2
WELCOME Welcome to the Marvel Experience Thank you for choosing our quality American-built product to add to your home. We are thrilled to welcome you to our growing community of Marvel owners, who trust in our products and our support. The information in this guide is intended to help you install and maintain your new Marvel undercounter model to protect and prolong its lifetime. We encourage you to contact our Technical Support team at (616) 754-5601 with any questions.
PAGE 3
TABLE OF CONTENTS Tip: Click on any section below to jump directly there Installation Integrated Panel Dimensions Integrated Panel Installation 3
PAGE 4
INTEGRATED PANEL DIMENSIONS • • Panel thickness 233⁄4" (603 mm) 1429⁄32" (379 mm) 117⁄8" (302 mm) 11 ⁄32" 13 4 Panel thickness cannot exceed 3/4" (19mm) If your overlay panel is thinner than 5/8" (15.9 mm) you will need to purchase shorter screws. The longer screws will break through the front of the panel.
PAGE 5
INTEGRATED PANEL INSTALLATION ! CAUTION It is important to use the factory provided grille that came with the product to assure proper air flow is maintained through the condenser. The use of a custom grille is not recommended and will void the warranty. Full Integrated Panel Installation Instructions Determine Wood Screw Requirements 1. A #10 pan head wood screw should be used to 2. properly secure the integrated panel. A quantity of 16 screws are supplied with the unit in the literature pack. 3.
PAGE 6
INTEGRATED PANEL INSTALLATION Step 1: Remove Drawers from unit. 1. Begin by pulling out the top drawer. Remove screws .35/.31 securing drawer to slides. Pull drawer forward, lift up (9 mm/7.5 mm) and out to clear clips in rear of drawer. Move drawer forward about 1" (2.5 cm) and set down on slides. At the .50 right rear corner of the drawer disconnect the display (12.5) wire harness. Remove the drawer from the unit by lifting up off of the slides.
PAGE 7
INTEGRATED PANEL INSTALLATION Step 3: Attach the Integrated Panel to the Drawer 1. Set the integrated panel on drawer front face and align edges. The custom integrated panel should be flush with the top of the drawer and centered on the width of the drawer. Clamp panel in position and mark pilot hole locations. Pick the required pilot hole size from the table below and drill the pilot holes ensuring not to drill all the way through the integrated panel.