Owners Guide

7
Installation Operation and Maintenance Instructions
Anti-Tip Bracket
1. Slide unit out so screws on top of unit are easily
accessible.
2. Remove the two screws from the opposite side of the hinge
assembly using a T-25 TORX driver (see below).
3. Place bracket over holes and attach to unit with two screws
removed in step 2 using a T-25 TORX driver. Tighten
screws fully.
4. Gently push unit into position. Be careful not to entangle
the electrical cord or water line, if applicable.
5. Check to be sure the unit is level from front to back and
side to side. Make any necessary adjustments. The unit’s
top surface should be approximately 1/8” (3 mm) below the
countertop.
6. Secure bracket into adjoining surface.
Side-by-Side Installation
Two units may be installed side-by-side.
Cutout width for a side-by-side installation is the cutout
dimension of a single unit times two.
No trim kit is required. However, 1/4” (6 mm) of space needs to
be maintained between the units to ensure unobstructed door
swing.
Units must operate from separate, properly grounded
electrical receptacles placed according to each unit’s electrical
specications requirements.
Side-by-Side Installation with Bracket
1. Slide both units out so screws on top of units are easily
accessible.
2. Remove screws as shown below.
3. Place bracket over holes and attach to unit with two screws
removed in step 2 using a T-25 TORX driver. Tighten
screws fully
4. Gently push units into position. Be careful not to entangle
the electrical cord or water line, if applicable.
5. Re-check the leveling, from front to back and side to side.
Make any necessary adjustments. The unit’s top surface
should be approximately 1/8” (3mm) below the countertop.