Owners Guide
10
Installation Operation and Maintenance Instructions
Install top hinge and door:
1. Use alternate hinge supplied with unit and reinstall the
screws. Do not tighten...
2. Lift the door on to the bottom hinge.
3. Align at edge of the hinge with the outer edge of the unit.
4. Tighten three hinge screws.
Align and adjust the door:
Align and adjust the door (see ALIGNMENT AND
ADJUSTMENT).
Install grille:
Install the grille.
First Use
Initial startup requires no adjustments. If the unit was turned off,
press and hold for 5 seconds to turn unit on. See “Control
Operation” section for more details.
NOTICE
Temperature displayed reects actual temperature inside
unit.
If the temperature displayed is different than selected, the unit
is progressing towards the selected temperature. Time to reach
set point varies based upon ambient temperature, temperature
of product loaded, door openings, etc. Marvel recommends
allowing the unit to reach set points before loading.
3. Remove door by tilting forward and lifting door off bottom
hinge. Retain shoulder washers; they will be reused.
4. Remove four screws from hinge holes on the opposite
side. Reinstall into holes where the hinge was removed.
Take care not to scratch cabinet.
Remove and reinstall bottom hinge:
1. Remove bottom hinge from cabinet by removing three
screws.
2. Remove corresponding screws on opposite side of
cabinet.
3. Flip hinge plate over and reinstall on opposite side.
Prepare door for reinstallation:
1. Remove gasket. This will reveal mounting holes for the
magnet assembly.
2. Remove magnet assembly from door with T-10 TORX
driver. Be sure to only remove the two screws holding the
assembly to the door. Reinstall on the opposite end of the
door.
3. Rotate gasket 180°, aligning notch with magnet assembly
and pressing rmly into the gasket channel starting at the
corners.
4. Rotate door 180° to reverse.