Service Manual

103
Section 14: Beer Dispenser
Caution Prior to preceding with any of the following steps the main
power to the appliance and/or the power cord should be disconnected from the
power supply. Failure to do so could result in severe shock.
14.1: Interior mechanical / electrical components
The components are accessible as described in previous sections.
 Remove all interior beer dispenser accessories: keg, co2 tank, regulators, and lines.
 Remove shelving in lieu of keg equipment (depending on customers’ installation).
 Remove plastic screw caps from freezer cover.
 Remove Phillips screws.
 Pull freezer cover away from back wall enough to disconnect the evaporator fan
harness.
 The interior fan, both thermistors, and the evaporator plate is now exposed.
 NOTE: The evaporator fan for the beer dispenser has reversed air flow compared to the
other Marvel models. The fan application is draw through. Interior cabinet air is pulled
through the fan orifice, across the evaporator plate, and outwards from the louvers on
the evaporator cover.
Note the two hole locations on the
photo to the left.
The hole on the left hand side is used
for factory test purposes only; this is
sealed with a white plastic cover.
The hole on the right hand side is
used as a port to accommodate an
optional field install kit for an
externally mounted CO2 tank. This
will also be sealed with a white plastic
cover.