Owners Guide

8
USING YOUR ELECTRONIC CONTROL
Starting your beverage center
Plug the beverage center power cord into a wall outlet. Your
beverage center will begin cooling after power is applied.
If your beverage center does not start, check that the bev-
erage center is turned on and the set temperature is cold
enough.
Turning your beverage center ON or OFF
If the beverage center is on, the beverage center tempera-
ture will be shown on the display. To turn the beverage
center off, press and hold the "ON/OFF" button for three (3)
seconds. "OFF" will appear on the display.
If the beverage center is not on, "OFF" will be shown on
the display. To turn the beverage center on, press and hold
the "ON/OFF" button for three (3) seconds. The beverage
center temperature will be shown on the display.
Set temperature
To set the beverage center temperature, press and hold
the "SET" button. When the "SET" button is pressed, the
display will show the set temperature. While holding the
"SET" button, press the "WARMER" or "COLDER" buttons
to adjust set temperature.
Beverage center operation
The available temperature range of the beverage center is
34° to 42°F (1° to 6° C).
It may take up to 24 hours for your beverage center to
reach desired temperature. This will depend on amount of
content loaded and number of door opening and closings.
For best results allow beverage center to "pull down" to
desired set temperature before loading. Once contents are
loaded, allow at least 48 hours for temperature to stabilize
before making any adjustments to the set temperature.
Alarms
Your Marvel Prime Controls™ will monitor beverage center
function and alert you with a series of audible and visual
alarms.
• Temperature Sensor Fault: If the control-
ler detects that the temperature sensor is
not properly functioning, a temperature
sensor alarm will sound in one (1) second intervals. "E1"
will ash on the display panel and the Alarm LED located
at the top left of the display below the word "Alarm" will be
illuminated. Please call Marvel Customer Service or your
dealer if this error code is displayed.
• High and Low Temperature Alarm: If the
storage compartment temperature deviates
excessively from the set-point temperature, the
alarm will sound in (1) second intervals. The
display panel will ash either "Hi" or "Lo" de-
pending upon the condition and the Alarm LED
light at the top left of the display below the word
"Alarm" will be illuminated. The alarm will remain active
until the condition is corrected.
Set
Colder Warmer
ON/OFF
Press and Hold Press and Hold
Alarm
F
Figure 11
Control
Assembly
Figure 10
close-up of
control
Light Switch
Door Switch
Control
• Door Ajar Alarm: If the door has been left
open for over ve (5) minutes, the alarm
will sound in one (1) second intervals. The
display panel will ash "do" and the Alarm LED located at
the top left of the display below the word "Alarm" will be il-
luminated. This will stop as soon as the door is closed.
NOTE
Alarm Mute
Press any key to mute the audible portion of an alarm.
This action will only mute the alarm. If the condition that
caused the alarm continues, the alarm code will continue to
ash and will sound for 20 seconds every 60 minutes.
NOTE
NOTE
After a high temperature alarm condition, check all perish-
ables to ensure they are safe for consumption.
The temperature alarm may occur as a result of high usage
or introduction of warm contents to the storage compart-
ment. If the temperature alarm continues to occur, your unit
may require service.