MARVEL DUAL ZONE WINE CELLAR Installation Operation and Maintenance Instructions Dual Zone Wine Cellar 6SDZE
UNPACKING YOUR DUAL ZONE WINE CELLAR Remove Packaging Your dual zone wine cellar has been packed for shipment with all parts that could be damaged by movement securely fastened. Before using, be sure all packing materials and tape have been removed. Important Keep your carton packaging until your dual zone wine cellar has been thoroughly inspected and found to be in good condition. If there is damage, the packaging will be needed as proof of damage in transit.
INSTALLING YOUR DUAL ZONE WINE CELLAR Select Location The proper location will ensure peak performance of your appliance. Choose a location where the unit will be out of direct sunlight and away from heat sources. Best performance will be maintained when installed within the following parameters: Electrical Plug Optional Location: Cutout shown for electrical outlet which can be located in adjacent cabinetry.
SENTRY SYSTEM™ REFRIGERATION MONITOR Figure 2 Start Your Appliance Your unit will start upon initial plug-in. The message center will display an amber “POWER FAILURE” message upon initial plug-in due to your unit being powered-on at the factory to verify performance and then powered-off. The Sentry System™ refrigeration monitor senses a power outage has occurred and relays this information to you when you initially power-up your unit.
DUAL ZONE WINE CELLAR FEATURES Independent Storage Compartments Both compartments can be set for either temperature range, red or white, but for more efficient energy usage and functionality of the unit, it is better to use the top compartment for reds (warmer) and the bottom compartment for whites (cooler). Front Bottles (Necks Facing Rear) Rear Bottles (Necks Facing Front) Insert Wine Bottles The five (5) upper shelves each hold eight (8) bottles in a vertical fashion.
CARE AND CLEANING OF YOUR DUAL ZONE WINE CELLAR Condenser The condenser tubing inside the cabinet does not require frequent cleaning; however, satisfactory cooling depends on adequate ventilation over the coils. Be sure that nothing obstructs the required air flow openings in front of the cabinet. At least once or twice a year, brush or vacuum lint and dirt from the condenser for efficient performance by unscrewing the grille on the bottom front of the cabinet.
TROUBLESHOOTING YOUR DUAL ZONE WINE CELLAR Before Calling for Service Before calling for service, check the troubleshooting table on this page. This table lists possible problems that you can remedy without difficulty to avoid an unnecessary service call. PROBLEM Odor in cabinet Noisy operation Cabinet vibrates Cabinet light not working POSSIBLE CAUSES/SOLUTIONS 1. Interior needs cleaning 1. Cabinet not level 2. Weak floor 1. Cabinet not level 2. Weak floor 1. Tube burned out 2. No power at outlet 1.
OBTAINING SERVICE FOR YOUR DUAL ZONE WINE CELLAR If You Do Need Service If you do need service, contact your dealer or Marvel Industries. In any correspondence, refer to the model number and serial number of your unit which is located on the upper left hand side of the wall liner. Retain your proof of purchase. You may want to record these numbers in the space below.
HOUSEHOLD PRODUCT WARRANTY Entire Product Limited One Year Parts and Labor Warranty Marvel warrants that it will supply all necessary parts and labor to repair or replace in the end user’s home or office, any component which proves to be defective in material or workmanship, subject to the condition and exclusions stated below, for a period of one year from the date of purchase by the end user.
www.lifeluxurymarvel.com Marvel Industries P.O. Box 997 Richmond, IN 47375-0997 Customer Service 800.428.6644 An AGA Company 41010959 Rev. A 02.18.08 All specifications and product designs subject to change without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions, replacements or compensation for previously purchased products.
