Use and Care Guide

23
PREPARING THE ICE MACHINE FOR STORAGE
To Restart the Ice Machine
1. With the rocker switch in the OFF position, plug the ice
machine into an electrical outlet.
2. Reconnect or turn on the water supply line.
3. Reconnect drain tubing if removed.
4. Turn the rocker switch to the ON position.
5. Check the water inlet, drain lines, and ttings for any
water leaks.
6. Check drain pump (if equipped) operation by pouring
approximately two (2) quarts of water into the ice stor-
age bin. The drain pump should activate and discharge
water (refer to Drain Pump on page 6). Check for water
leaks at all hose connections.
Figure 24
Back view of
ice machine
Water supply
tting
Water
supply
line
Water valve
inlet
Access
cover
Screw
Figure 24a
Figure 25
To disconnect the water outlet
line: Push up on the white collar
and pull the plastic water line
from the bottom of the water
valve.
To reconnect the water outlet
line: Simply insert the plastic
tubing into the white collar and
push until it stops (about
1
⁄2", 12
mm, of water line will enter the
valve).
White
collar
Plastic outlet
water line
Figure 26
Figure 26a